FIRE RESISTANT CABLE COATING COMPOUND is a asbestos free, non-toxic, single component ready to use inorganic compound which prevent the propagation of fire along electrical cables.

Compound when exposed to Fire starts intumescent immediately thereby forming a char on the cables and acts as on barrier for the substrate against flame and heat, hence not allowing propagation of fire along electrical cables.

Application: Pre-application surface shall be free of dust, grease & Oil.  Cable Coating should be thoroughly stirred before application.  The Coating shall be applied by normal brushing application on the cable first a thin layer allow it to touch dry then second coat shall be applied, if required third coat can be applied to achieve a wet film thickness of 2 mm which shall give a dry film thickness of 1.5 mm.

Shall be applied 2 meters in bunched cables running horizontally at an intermittent distance of 10 meters.

All the vertical runs shall be fully coated as the Fire travels faster in verticals with the draft effect.

Cables at all entry / exit points up to 2 meters

Cables in High Heat zones.

Cables at crises-crossings all sides up to 2 meters

Cables in area of Oil / Lubricant spillage, coal dust etc.